Charcoal Briquetting Machine Maintenance Precautions

The following are the precautions for charcoal briquetting machine maintenance and maintenance:

1. Daily maintenance precautions for charcoal briquetting machine

Cleaning work

After each use, clean the dust, charcoal debris and other debris on the surface of the charcoal briquetting machine in time.

Especially the machine's feed port, molding mold and discharge port.

For the hard-to-reach parts inside the machine, compressed air can be used for blowing.

Lubrication work

Regularly lubricate the bearings, screws and transmission chains of the charcoal briquetting machine. Generally speaking, these parts need to be lubricated once a week or every two weeks.

Check the connection of components

Before starting the machine every day, check the connecting bolts between the motor and the main machine and the fixing bolts of the molding mold.

2. Precautions for regular maintenance of charcoal briquetting machine

• It is recommended to check the electrical system of the machine once a month. Check whether the wires are damaged or aged.
• Clean the dust inside the electrical control cabinet. Excessive dust accumulation may affect the heat dissipation of electrical components and reduce their performance.
• Inspect the main mechanical components of the machine every 3-6 months.
• Check the wear of the screw. The screw is one of the key components of the charcoal briquetting machine. Its wear will affect the conveying and compression effect of the material. If the screw is severely worn, it should be replaced in time.
• The molding mold also needs to be checked regularly. When it is found that the molding size of the mold does not meet the requirements or there are obvious scratches or depressions on the surface, it should be repaired or replaced.
• Check the tightness of the belt and chain. Too loose or too tight is not good. Adjust to the appropriate tightness according to the instruction manual of the charcoal briquetting machine.
• Regularly calibrate the pressure system of the machine. The pressure of the charcoal briquetting machine is crucial to the molding quality of the charcoal blocks. You can use professional pressure testing equipment to check the accuracy of the pressure sensor and adjust it according to the actual situation.
• For machines with temperature control requirements (such as some charcoal briquetting machines that use heating devices to assist molding), check the working status of the temperature sensor and the heating element to ensure that the temperature is controlled within the appropriate range. Too high temperature may cause the charcoal raw materials to burn, and too low temperature may not achieve a good molding effect.

3.What are the wearing parts of the charcoal briquetting machine?

1.Mold

The mold is the key component of the charcoal briquetting machine, which directly determines the shape and size of the charcoal molding.

A high-quality mold can be used for several months to a year, while a mold of poor quality or used in a harsh environment may only last a few weeks.

2. Pressure roller

The pressure roller is mainly used to crush and transport raw materials.

The pressure roller can be used for about several months. If the raw material contains corrosive substances or the equipment speed is too high or the pressure is too high, the service life of the pressure roller will be significantly shortened.

3.Bearings

Bearings play the role of supporting rotating parts in the charcoal briquetting machine.

High-quality bearings can last for more than a year, but if the environment is harsh or improperly maintained, they may become damaged in a few months.

4. Propeller (if any)

Augers are used to transport raw materials to the briquetting area

Depending on the characteristics of the raw materials and frequency of use, it can be used for about half a year to a year.